Single 10" Standard Vehicle System - 1-TBS 1043 DV Ultra

Plan your next bass build around the TrueBass Solutions Single 10" Standard Vehicle System, featuring one TBS 1043 DV Ultra woofer. With listed power handling of 600 watts RMS and 1400 watts peak, this configuration gives you a defined starting point for selecting compatible amplification.

Whether you are refreshing an existing setup or building a dedicated subwoofer system for your daily driver, start with the space you have. The enclosure measures 21.5" wide × 13.5" high × 15" deep, with rear-mounted binding posts for wiring access. Picture your next drive with a dedicated woofer handling the low end of your music, supported by an installation planned around fit, wiring and amplifier compatibility.

Woofer:

• One TBS 1043 DV Ultra 10" woofer

Voice-Coil Inside Diameter:

• 3 inches.

Driver Sensitivity:

• 93 dB at 1 watt/1 meter.

Driver Fs:

• Free-air resonance frequency (Fs): 36 Hz. This is a driver parameter, separate from enclosure resonance.

Driver Parameters:

• Qms: 4.22.
• Qes: 0.43.
• Qt: 0.39.
• Vas: 2.2 cu. ft. This is a driver parameter, not the internal enclosure volume.

Woofer & Magnet Weight:

• Total woofer weight: 20 lbs, including the magnet.
• Magnet weight: 180 oz per woofer (1 × 180 oz magnet). These component weights are included in the total finished product weight below, not added on top.

Box Impedance:

• 4 / 4 Ω

Power Handling (RMS / Peak):

• 600 / 1400 watts
• Use the RMS rating when planning compatible amplification; peak handling is not a continuous-power rating.

Total Finished Product Weight:

• 64 lbs, including the enclosure, woofer, magnet, and hardware.

Dimensions:

• 21.5" wide × 13.5" high × 15" deep
• Allow clearance for rear wiring and secure mounting when checking fit.

Internal Enclosure Volume:

• 1.5 cu. ft. gross internal volume, before woofer and port deductions.

Ports:

• One round port, 3 inches in diameter × 9 inches long.

Inputs & Wiring:

• Two pairs of heavy gold-plated binding posts positioned on the rear, configured to 4 ohms each (4 / 4 ohms).
• Match the final wiring impedance to your amplifier's supported load.

Enclosure Resonance:

• 34 Hz

System F3:

• 36 Hz, separate from driver Fs and enclosure resonance.

Before You Order:

• Measure your planned mounting location and compare it with the full enclosure dimensions.
• Plan secure mounting and suitable handling for the 64 lb system.
• Confirm amplifier compatibility with the power handling and intended wiring.
• Contact TrueBass Solutions with your vehicle details, available space and amplifier information if you need help planning your setup.